Diy Deer Feeder Trough

Diy Deer Feeder Trough. This will form the trough for your deer feeder. Dig and bury the 4x4s in 2' holes into the ground for fixed legs of the feeder.

Our new deer trough! Deer hunting stands, Deer feeders from www.pinterest.ca

Dig and bury the 4x4s in 2’ holes into the ground for fixed legs of the feeder. Dig and bury the 4x4s in 2' holes into the ground for fixed legs of the feeder. Another important tip is to build the feet of the trough from 4x6 lumber and cut one end at an angle, to create a “skid.”.

Source: www.pinterest.de

The best way to prevent deck planters from rotting is with a liner. Build a deer feeder in the style of a trough!

Source: www.ledimage.co

Steps on how to build a deer feeder. This is the perfect diy deer feeder if you have a corn trough lying around, not being used.

Source: www.pinterest.com

Steps on how to build a deer feeder. Find a plastic storage container that can be used for a trough bucket and measure the container.

Source: www.pinterest.com

Cut wood boards to the sizes needed for the ten pieces of the trough frame, drill the boards together and drill the container onto the frame. These plastic buckets are cheap and can be bought at any building supply center.

Source: www.pinterest.ca

Dig and bury the 4x4s in 2’ holes into the ground for fixed legs of the feeder. This is the perfect diy deer feeder if you have a corn trough lying around, not being used.

Your Trough Is Now Complete And Can Be Sanded If Desired Or Left Rough But We Suggest A Little Sanding To Remove Any Sharp Edges.

Dig and bury the 4x4s in 2’ holes into the ground for fixed legs of the feeder. Moreover, if you are already spending much on your hunting hobby, you must think of saving some money when it comes to equipment. This will easily hold an average of 200 pounds of feed.

Killed 6 The First Night The Trap Was Set.

I just did that with a water trough the hogs were messing up. The best way to prevent deck planters from rotting is with a liner. Few design considerations are very important such as height of roof and trough.

This Is The Perfect Diy Deer Feeder If You Have A Corn Trough Lying Around, Not Being Used.

Should you line a wooden trough? Find a plastic storage container that can be used for a trough bucket and measure the container. Trap 'em at the site as well.

Gather Up Your 2X4 And Cut It To 36 In Length And Rip It Into Two Equal Halves.

Now it's time for the legs. Dig and bury the 4x4s in 2' holes into the ground for fixed legs of the feeder. Cut wood boards to the sizes needed for the ten pieces of the trough frame, drill the boards together and drill the container onto the frame.

Drill Out Four 5/8 Drain Holes In The Trough's Vee Bottom.

This is similar to the other trough, but here you will instead add a large bowl in the center of the trough over a base. Up off the ground on a frame, the deer can reach it but not the hogs. On the other hand, the trough should be at least 24” from the ground.